• If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Xin chào ! Nếu đây là lần đầu tiên bạn đến với diễn đàn, xin vui lòng danh ra một phút bấm vào đây để đăng kí và tham gia thảo luận cùng VnPro.

Announcement

Collapse
No announcement yet.

Lab 1-8: Nạp IOS từ TFTP Server cho router chạy từ Flash

Collapse
This is a sticky topic.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Lab 1-8: Nạp IOS từ TFTP Server cho router chạy từ Flash

    Lab 1-8: Nạp IOS Image từ TFTP Server cho router chạy từ Flash


    Mô tả
    –Bài thực hành này mô tả cách nạp IOS từ router chạy từ flash. Một số router chạy từ flash như Cisco 2500 series hay Cisco 1600 series.
    –PC họat động như một TFTP server sẽ nối với router trong cùng mạng LAN. IOS image mới sẽ chứa trong TFTP server và sẽ được truyền qua Cisco router bằng giao thức truyền TFTP. Trong hình vẽ này, PC hoạt động như TFTP server còn router sẽ là TFTP client.

    Router chạy từ Flash và router chạy từ RAM
    Cisco router có thể thực thi IOS từ RAM hay từ Flash, chạy từ flash chậm hơn.
    – Router chạy từ flash là các loại Cisco 2500 series và một số router Cisco 1600 series. Toàn bộ IOS được nạp vào bộ nhớ flash ở dạng không nén. Cisco IOS chạy từ flash. Cập nhật IOS mới trở thành vấn đề: làm sao để nạp vào flash trong khi đang thực thi IOS cũ? Cisco giải quyết điều này bằng một IOS đặc biệt lưu trong ROM. Chương trình giúp đỡ khởi động sẽ nạp lại router để boot từ ROM. Lúc này Flash có thể cập nhật và IOS mới sẽ có thể chạy từ flash.
    – Router chạy từ RAM là các đời router Cisco 3600, 4000, 7000, và 7500. Các router này chứa IOS image dạng nén trong flash. Khi khởi động, router sao chép IOS từ flash vào trong RAM và thực thi IOS trên RAM. Các router này có thể cập nhật dễ dàng IOS trong flash bằng cách chép phiên bản mới bằng TFTP.
    Thực hiện
    –Ban đầu cấu hình của RouterA như sau

    RouterA
    !
    hostname RouterA
    !
    interface Ethernet0
    ip address 10.10.3.253 255.255.255.0 ← Ethernet interface trên cùng mạng với TFTP server
    no shut ← cho phép cổng
    !
    line con 0
    line aux 0
    line vty 0 4
    login
    !
    end

    Dùng lệnh show version để tìm phiên bản của IOS hiện có.

    RouterA#show version
    Cisco Internetwork Operating System Software
    IOS (tm) 2500 Software (C2500-I-L), Version 12.1(3), RELEASE SOFTWARE (fc1)

    Router đang chạy IOS version 12.1(3)

    Copyright (c) 1986-2000 by cisco Systems, Inc.
    Compiled Thu 06-Jul-00 07:33 by cmong
    Image text-base: 0x0303E710, data-base: 0x00001000

    ROM: System Bootstrap, Version 11.0(10c), SOFTWARE
    BOOTFLASH: 3000 Bootstrap Software (IGS-BOOT-R), Version 11.0(10c), RELEASE SOFTWARE (fc1)

    R1 uptime is 1 hour, 22 minutes
    System returned to ROM by power-on
    System image file is "flash:c2500-i-l.121-3.bin"

    IOS được nạp từ flash

    cisco 2511 (68030) processor (revision M) with 14336K/2048K bytes of memory. ↑
    Router có 16 MB RAM, 14MB dùng cho bộ nhớ xử lý, 2MB dùng
    cho bộ nhớ I/O
    Processor board ID 07143970, with hardware revision 00000000
    Bridging software.
    X.25 software, Version 3.0.0.
    1 Ethernet/IEEE 802.3 interface(s)
    2 Serial network interface(s)
    16 terminal line(s)
    32K bytes of non-volatile configuration memory.
    8192K bytes of processor board System flash (Read ONLY) ← router có 8 MB flash
    Configuration register is 0x2102

    –Xem nội dung bộ nhớ flash dùng lệnh show flash

    RouterA#show flash
    System flash directory:
    File Length Name/status
    1 7640212 c2500-i-l.121-3.bin
    [7640276 bytes used, 748332 available, 8388608 total]

    Để chắc chắn có thể truy cập được TFTP server ở địa chỉ 10.10.3.28, dùng lệnh ping để kiểm tra.

    RouterA#ping 10.10.3.28
    Type escape sequence to abort.
    Sending 5, 100-byte ICMP Echos to 10.10.3.28 timeout is 2 seconds:
    !!!!!
    Success rate is 100 percent (5/5), round-trip min/avg/max = 4/4/4 ms

    –Sau khi đã kiểm tra kết nối đến TFTP server như trên, ta bắt đầu nạp IOS mới vào router bằng lệnh copy tftp flash.
    –Lưu ý dòng sản phẩm Cisco 2500 là lọai router chạy từ flash.

    RouterA#copy tftp flash
    **** NOTICE ****
    Flash load helper v1.0
    This process will accept the copy options and then terminate
    the current system image to use the ROM based image for the copy. ← router sẽ nạp IOS image
    trong ROM, IOS này sẽ ghi IOS mới vào flash
    Routing functionality will not be available during that time.
    If you are logged in via telnet, this connection will terminate.
    Users with console access can see the results of the copy operation.
    ---- ******** ----
    Proceed? [confirm]
    Address or name of remote host [255.255.255.255]? 10.10.3.28 ← địa chỉ TFTP server
    Source file name []?c2500-i-l.121-4.bin
    Destination file name []?
    Accessing tftp://10.10.3.28/c2500-i-l.121-4.bin...
    Erase flash: before copying? [confirm] ← xoá nội dung hiện tại của flash

    Loading System flash directory:
    File Length Name/status
    1 7640212 c2500-i-l.121-3.bin
    [7640276 bytes used, 748332 available, 8388608 total]
    Accessing file 'c2500-i-l.121-4.bin' on 10.10.3.28...
    Loading c2500-i-l.121-4.bin from 10.10.3.28 (via Ethernet0):! [OK]

    Erasing device... eeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee ...erased
    Loading c2500-i-l.121-4.bin from 10.10.3.28 (via Ethernet0): !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
    !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
    !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
    [OK - 7640212/8388608 bytes]

    Verifying checksum... OK (0x1FC7)
    Flash copy took 0:03:47 [hh:mm:ss]
    %FLH: Re-booting system after download

    Restricted Rights Legend
    ...
    Cisco Internetwork Operating System Software
    IOS (tm) 2500 Software (C2500-I-L), Version 12.1(4), RELEASE SOFTWARE (fc1)
    Copyright (c) 1986-2000 by cisco Systems, Inc.
    Compiled Thu 06-Jul-00 07:33 by cmong
    Image text-base: 0x0303E710, data-base: 0x00001000

    cisco 2511 (68030) processor (revision M) with 14336K/2048K bytes of memory.
    Processor board ID 07143970, with hardware revision 00000000
    Bridging software.
    X.25 software, Version 3.0.0.
    1 Ethernet/IEEE 802.3 interface(s)
    2 Serial network interface(s)
    16 terminal line(s)
    32K bytes of non-volatile configuration memory.
    8192K bytes of processor board System flash (Read ONLY)

    Press RETURN to get started!

    –Sau khi đã nạp IOS mới dùng lệnh show version để kiểm tra lại router đã chạy IOS mới chưa:

    RouterA#show version

    –Kiểm tra lại lần nữa bằng show flash.
    Last edited by tranmyphuc; 25-08-2008, 10:16 PM.
    Email : vnpro@vnpro.org
    ---------------------------------------------------------------------------------------------------------------
Trung Tâm Tin Học VnPro
149/1D Ung Văn Khiêm P25 Q.Bình thạnh TPHCM
Tel : (08) 35124257 (5 lines)
Fax: (08) 35124314

Home page: http://www.vnpro.vn
Support Forum: http://www.vnpro.org
- Chuyên đào tạo quản trị mạng và hạ tầng Internet
- Phát hành sách chuyên môn
- Tư vấn và tuyển dụng nhân sự IT
- Tư vấn thiết kế và hỗ trợ kỹ thuật hệ thống mạng

Network channel: http://www.dancisco.com
Blog: http://www.vnpro.org/blog
Working...
X