• If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Xin chào ! Nếu đây là lần đầu tiên bạn đến với diễn đàn, xin vui lòng danh ra một phút bấm vào đây để đăng kí và tham gia thảo luận cùng VnPro.

Announcement

Collapse
No announcement yet.

New CCNA – New Questions 2

Collapse
This is a sticky topic.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • New CCNA – New Questions 2

    Question 2


    Q2 (Etherchannel Questions that goes like this)
    Refer to the exhibit. Etherchannel has been configured on Switch1 as shown.

    Switch1# conf t
    Switch1(config)# interface range gigabitethernet 1/1
    Switch1(config)# Channel-group 5 Mode “AUTO”
    Switch1#
    Switch1(config)# interface range gigabitethernet 1/2
    Switch1(config)# Channel-group 5 Mode “AUTO”


    Which is the correct command set to configure etherchannel on Switch2?


    A.
    Switch2# configure terminal
    Switch2(config)# interface range gigabitethernet3/1 -2
    Switch2(config-if)# channel-group 5 mode auto

    B.
    Switch2# configure terminal
    Switch2(config)# interface range gigabitethemet3/1 -2
    Switch2(config-if)# channel-group 5 mode passive
    C.
    Switch2# configure terminal
    Switch2(config)# interface range gigabitethernet3/1 -2
    Switch2(config-if)# channel-group 5 mode desirable
    D.
    Switch2# configure terminal
    Switch2(config)# interface range gigabitethernet3/1 -2
    Switch2(config-if)# channel-group 5 mode ACTIVE

    Answer: C

    Good resource: http://www.cisco.com/en/US/docs/swit...html#wp1028480

    Question 3


    Which OSPF command turn OSPF on all interfaces of a router?

    Answer:
    network 0.0.0.0 255.255.255.255


    Question 4



    Network admin creates a layer 3 Etherchannel, bounding 4 interfaces into channel group 1. On what interface is the IP address configured?
    A. the port-channel 1 interface
    B. the highest number member interface
    C. all member interfaces
    D. the lowest number member interface


    Answer: A
Working...
X