• If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Xin chào ! Nếu đây là lần đầu tiên bạn đến với diễn đàn, xin vui lòng danh ra một phút bấm vào đây để đăng kí và tham gia thảo luận cùng VnPro.

Announcement

Collapse
No announcement yet.

New CCNA – HSRP VRRP GLBP

Collapse
This is a sticky topic.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • New CCNA – HSRP VRRP GLBP

    Note: If you are not sure about HSRP and GLBP, please read our HSRP tutorial and GLBP tutorial.
    Question 1
    Which one of these is a valid HSRP Virtual Mac Address?
    A. 0000.0C07.AC01
    B. 0000.5E00.0110
    C. 0007.B400.1203
    D. 0000.C007.0201

    Answer: A
    Explanation
    With HSRP, two or more devices support a virtual router with a fictitious MAC address and unique IP address. There are two version of HSRP.
    + With HSRP version 1, the virtual router’s MAC address is 0000.0c07.ACxx , in which xx is the HSRP group.
    + With HSRP version 2, the virtual MAC address if 0000.0C9F.Fxxx, in which xxx is the HSRP group.
    Note: Another case is HSRP for IPv6, in which the MAC address range from 0005.73A0.0000 through 0005.73A0.0FFF.
    -> A is correct.
    (Good resource for HSRP: http://www.cisco.com/en/US/docs/swit...e/l3_hsrp.html)
    Question 2
    Which three statements about HSRP operation are true? (Choose three)
    A. The virtual IP address and virtual MAC address are active on the HSRP Master router.
    B. The HSRP default timers are a 3 second hello interval and a 10 second dead interval.
    C. HSRP supports only clear-text authentication.
    D. The HSRP virtual IP address must be on a different subnet than the routers’ interfaces on the same LAN.
    E. The HSRP virtual IP address must be the same as one of the router’s interface addresses on the LAN.
    F. HSRP supports up to 255 groups per interface, enabling an administrative form of load balancing.

    Answer: A B F
    Explanation
    The virtual MAC address of HSRP version 1 is 0000.0C07.ACxx, where xx is the HSRP group number in hexadecimal based on the respective interface. For example, HSRP group 10 uses the HSRP virtual MAC address of 0000.0C07.AC0A. HSRP version 2 uses a virtual MAC address of 0000.0C9F.FXXX (XXX: HSRP group in hexadecimal)
    For more information about HSRP operation, please read our HSRP tutorial.
    Question 3
    Which statement describes VRRP object tracking?
    A. It monitors traffic flow and link utilization.
    B. It ensures the best VRRP router is the virtual router master for the group.
    C. It causes traffic to dynamically move to higher bandwidth links
    D. It thwarts man-in-the-middle attacks.

    Answer: B
    Explanation
    Object tracking is the process of tracking the state of a configured object and uses that state to determine the priority of the VRRP router in a VRRP group -> B is correct.
    (Reference: http://www.cisco.com/c/en/us/td/docs...html#wp1074871)
    Note: Unlike HSRP which can track interface status directly, VRRP can only track interface status through a tracked object.
    Question 4
    In GLBP, which router will respond to client ARP requests?
    A. The active virtual gateway will reply with one of four possible virtual MAC addresses.
    B. All GLBP member routers will reply in round-robin fashion.
    C. The active virtual gateway will reply with its own hardware MAC address.
    D. The GLBP member routers will reply with one of four possible burned in hardware addresses.

    Answer: A
    Explanation
    One disadvantage of HSRP and VRRP is that only one router is in use, other routers must wait for the primary to fail because they can be used. However, Gateway Load Balancing Protocol (GLBP) can use of up to four routers simultaneously. In GLBP, there is still only one virtual IP address but each router has a different virtual MAC address. First a GLBP group must elect an Active Virtual Gateway (AVG). The AVG is responsible for replying ARP requests from hosts/clients. It replies with different virtual MAC addresses that correspond to different routers (known as Active Virtual Forwarders – AVFs) so that clients can send traffic to different routers in that GLBP group (load sharing).
    Question 5
    In a GLBP network, who is responsible for the arp request?
    A. AVF
    B. AVG
    C. Active Router
    D. Standby Router

    Answer: B
    Question 6
    What are three benefits of GLBP? (Choose three)
    A. GLBP supports up to eight virtual forwarders per GLBP group.
    B. GLBP supports clear text and MD5 password authentication between GLBP group members.
    C. GLBP is an open source standardized protocol that can be used with multiple vendors.
    D. GLBP supports up to 1024 virtual routers.
    E. GLBP can load share traffic across a maximum of four routers.
    F. GLBP elects two AVGs and two standby AVGs for redundancy.

    Answer: B D E


    Question 5
    What are three reasons to collect NetFlow data on a company network? (Choose three)
    A. To identify applications causing congestion.
    Phạm Minh Tuấn

    Email : phamminhtuan@vnpro.org
    Yahoo : phamminhtuan_vnpro
    -----------------------------------------------------------------------------------------------
Trung Tâm Tin Học VnPro
149/1D Ung Văn Khiêm P25 Q.Bình thạnh TPHCM
Tel : (08) 35124257 (5 lines)
Fax: (08) 35124314

Home page: http://www.vnpro.vn
Support Forum: http://www.vnpro.org
- Chuyên đào tạo quản trị mạng và hạ tầng Internet
- Phát hành sách chuyên môn
- Tư vấn và tuyển dụng nhân sự IT
- Tư vấn thiết kế và hỗ trợ kỹ thuật hệ thống mạng

Network channel: http://www.dancisco.com
Blog: http://www.vnpro.org/blog
Working...
X