Nhờ AE Review dịch vụ FTTH

[fanccna]

Cấu hình Cisco 878 với đường ADSL.
ADSL#sh run
Building configuration...

Current configuration : 1353 bytes
!
version 12.4
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname ADSL
!
boot-start-marker
boot-end-marker
!
enable password xxxxxx
no aaa new-model
!
resource policy
!
ip subnet-zero
ip cef
!
!
vpdn enable
!
!
!
!
username admin
!
!
controller DSL 0
line-term cpe
!
!
!
!
interface BRI0
no ip address
encapsulation hdlc
shutdown
!
interface FastEthernet0
!
interface FastEthernet1
!
interface FastEthernet2
!
interface FastEthernet3
!
interface Vlan1
ip address 192.168.1.1 255.255.255.0
ip nat inside
ip virtual-reassembly
pppoe enable group global
pppoe-client dial-pool-number 1
!
interface Dialer1
mtu 1492
ip address negotiated
ip nat outside
ip virtual-reassembly
encapsulation ppp
dialer pool 1
dialer-group 1
ppp authentication pap callin
ppp pap sent-username xxxxx password 0 xxxxxx
!
ip classless
ip route 0.0.0.0 0.0.0.0 Dialer1
!
no ip http server
no ip http secure-server
ip nat inside source list 1 interface Dialer1 overload
!
access-list 1 permit 192.168.1.0 0.0.0.255
dialer-list 1 protocol ip permit
dialer-list 100 protocol ip permit
!
control-plane
!
!
line con 0
password xxxxx
login
no modem enable
line aux 0
line vty 0 2
password xxxxx
login
line vty 3 4
login
!
scheduler max-task-time 5000
end

ADSL#sh ip int brie
ADSL#sh ip int brief
Interface IP-Address OK? Method Status Prot
ocol
FastEthernet0 unassigned YES unset down down

FastEthernet1 unassigned YES unset up up

FastEthernet2 unassigned YES unset down down

FastEthernet3 unassigned YES unset down down

BRI0 unassigned YES unset administratively down down

BRI0:1 unassigned YES unset administratively down down

BRI0:2 unassigned YES unset administratively down down

Vlan1 192.168.1.1 YES manual up up

Dialer1 221.132.49.17 YES IPCP up up

Virtual-Access1 unassigned YES unset up up

NVI0 unassigned YES unset up up


ADSL#ping 203.162.4.1 source 192.168.1.1

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 203.162.4.1, timeout is 2 seconds:
Packet sent with a source address of 192.168.1.1
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 32/32/32 ms