• If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Xin chào ! Nếu đây là lần đầu tiên bạn đến với diễn đàn, xin vui lòng danh ra một phút bấm vào đây để đăng kí và tham gia thảo luận cùng VnPro.

Announcement

Collapse
No announcement yet.

link local,site local admin local..

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • link local,site local admin local..

    em dang đọc dịa chỉ multicast của ipv6 nhưng mà chổ phạm vi của các dịa chỉ multicast em hơi bị rối
    các bác dịnh nghĩa giúp em rõ hơn chổ cái nha ,
    trong dịa chỉ multicast có trường scope với các giá trị scope khác nhau thì phạm vi của multicsat đó khác nhau
    scope=1 :interface local(node local)
    scope=2 : link local
    scope=3 :subnet local
    scope=4 : admin local
    các bác giàng kĩ them cho em biết phạm vi giới hạn của các khái niệm như node local,link local .subnet local,admin local nó như thế nào
    thank cá bác nhiều

  • #2
    Câu trả lời cho bạn đây

    0 reserved
    1 Interface-Local scope
    2 Link-Local scope
    3 reserved
    4 Admin-Local scope
    5 Site-Local scope
    6 (unassigned)
    7 (unassigned)
    8 Organization-Local scope
    9 (unassigned)
    A (unassigned)
    B (unassigned)
    C (unassigned)
    D (unassigned)
    E Global scope
    F reserved

    Interface-Local scope spans only a single interface on a node
    and is useful only for loopback transmission of multicast.

    Link-Local multicast scope spans the same topological region as
    the corresponding unicast scope.

    Admin-Local scope is the smallest scope that must be
    administratively configured, i.e., not automatically derived
    from physical connectivity or other, non-multicast-related
    configuration.

    Site-Local scope is intended to span a single site.

    Organization-Local scope is intended to span multiple sites
    belonging to a single organization.

    scopes labeled "(unassigned)" are available for administrators
    to define additional multicast regions.

    Trích RFC 4291

    FF0X::/8
    Scope ở đây là X (4 bit) nha bạn.
    Thường ở trình độ CCNP chúng ta chỉ quan tâm tới link local scope. Vì nó liên quan khá nhiều tới giao thức định tuyến
    VD:
    FE02::1 (tương tự subnet broadcast address VD 192.168.1.255/24)
    OSPF FE02::5 và FE02::6 (tương tự 224.0.0.5 và 224.0.0.6)
    Last edited by nbhduoc; 25-08-2011, 08:43 PM.
    Nguyễn Bá Hiển
    Email: nguyenbahien@vnpro.org
    Yahoo: nguyenbahien_vnpro
    ------------------------------------------------------------------------------------------------------------
Trung Tâm Tin Học VnPro
149/1D Ung Văn Khiêm P25 Q.Bình thạnh TPHCM
Tel : (08) 35124257 (5 lines)
Fax: (08) 35124314

Home page: http://www.vnpro.vn
Support Forum: http://www.vnpro.org
- Chuyên đào tạo quản trị mạng và hạ tầng Internet
- Phát hành sách chuyên môn
- Tư vấn và tuyển dụng nhân sự IT
- Tư vấn thiết kế và hỗ trợ kỹ thuật hệ thống mạng

Network channel: http://www.dancisco.com
Blog: http://www.vnpro.org/blog

Comment


  • #3
    Thầy Hiển giải thích thêm chỗ :

    Interface-Local scope spans only a single interface on a node
    and is useful only for loopback transmission of multicast.

    Nó khác Link-local scope chỗ nào ?

    Thấy FF01::1 ghi là all node, mà FF02::1 cũng ghi là all node

    Comment

    • Working...
      X