02-02-2004, 05:54 AM
Hi,
I have a question.
When the configuration file in NVRAM (start-up configuration file) has been erased and we need to config it without enter set up mode, besides the parametters such as
- hostnames,
- password on console line, aux line and all vty lines,
- enable secret password, IP address for active interfaces,
- RIP routing protocol and associated network numbers,
- and IP host lookup table must be set up,
is there anything else primarily need to be set up? (in interface s0/0 : no encap x25, encap HDLC for example)
I have a question.
When the configuration file in NVRAM (start-up configuration file) has been erased and we need to config it without enter set up mode, besides the parametters such as
- hostnames,
- password on console line, aux line and all vty lines,
- enable secret password, IP address for active interfaces,
- RIP routing protocol and associated network numbers,
- and IP host lookup table must be set up,
is there anything else primarily need to be set up? (in interface s0/0 : no encap x25, encap HDLC for example)